电子电路基础（第2版）（影印版）

　　1 Introduction
　　1.1 Electronic Systems
　　1.2 The Design Process
　　1.3 Integrated Circuits
　　1.4 Basic Amplifier Concepts
　　1.5 Cascaded Amplifiers
　　1.6 Power Supplies and Efficiency
　　1.7 Decibel Notation
　　1.8 Amplifier Models
　　1.9 Ideal Amplifiers
　　1.10 Amplifier Frequency Response
　　1.11 Differential Amplifiers
　　Summary
　　Problems
　　2 Operational Amplifiers
　　2.1 The Ideal Operational Amplifier
　　2.2 The Summing-Point Constraint
　　2.3 The Inverting Amplifier
　　2.4 The Noninverting Amplifier
　　2.5 Design of Simple Amplifiers
　　2.6 Op-Amp Imperfections in the Linear Range of Operation
　　2.7 Large-Signal Operation
　　2.8 DC Imperfections
　　2.9 Computer-Aided Analysis of Op-Amp Circuits
　　2.10 A Collection of Amplifier Circuits
　　2.11 Integrators and Differentiators
　　Summary
　　Problems
　　3 Diodes and Diode Circuits
　　3.1 Diode Characteristics
　　3.2 Load-Line Analysis
　　3.3 The Ideal-Diode Model
　　3.4 Rectifier Circuits
　　3.5 Wave-Shaping Circuits
　　3.6 Diode Logic Circuits
　　3.7 Voltage-Regulator Circuits
　　3.8 Linear Small-Signal Equivalent Circuits
　　3.9 Basic Semiconductor Concepts
　　3.10 Physics of the Junction Diode
　　3.11 Switching and High-Frequency Behavior
　　3.12 Computer-Aided Analysis of Diode Circuits
　　Summary
　　Problems
　　Anatomy of a Circuit Design:
　　A Function Generator
　　4 Bipolar Junction Transistors
　　4.1 Basic Operation of the npn Bipolar Junction Transistor
　　4.2 Load-Line Analysis of a Common-Emitter Amplifier
　　4.3 The pnp Bipolar Junction Transistor
　　4.4 Large-Signal DC Circuit Models
　　4.5 Large-Signal DC Analysis of BJT Circuits
　　4.6 Small-Signal Equivalent C8ircuits
　　4.7 The Common-Emitter Amplifier
　　4.8 The Emitter Follower
　　4.9 The BJT as a Digital Logic
　　Switch
　　Summary
　　Problems
　　5 Field-Effect Transistors
　　5.1 NMOS Transistors
　　5.2 Load-Line Analysis of a Simple NMOS Amplifier
　　5.3 Bias Circuits
　　5.4 Small-Signal Equivalent Circuits
　　5.5 The Common-Source Amplifier
　　5.6 The Source Follower
　　5.7 JFETs, Depletion-Mode MOSFETs, and p-Channel Devices
　　Summary
　　Problems
　　Anatomy of a circuit Design:
　　A Discrete Multistage Amplifier
　　6 Digital Logic Circuits
　　6.1 Basic Concepts
　　6.2 Electrical Specifications for Logic Gates
　　6.3 The Resistor-Pull-Up NMOS Inverter
　　6.4 Dynamic Response of the Resistor-Pull-Up NMOS Inverter
　　6.5 The CMOS Inverter
　　6.6 Propagation Delay of the CMOS Inverter
　　6.7 CMOS NOR and NAND Gates
　　6.8 Dynamic Logic
　　6.9 The CMOS Transmission Gate and Pass Transistor Logic
　　Summary
　　Problems
　　7 Differential and Multistage IC Amplifiers
　　7.1 Design Rules for Discrete and Integrated Circuits
　　7.2 IC Biasing with BJTs
　　7.3 IC Biasing with FETs
　　7.4 Large-Signal Analysis of the Emitter-Coupled Differential Pair
　　7.5 Small-Signal Equivalent-Circuit Analysis of the Emitter-Coupled
　　Differential Pair
　　7.6 Design of the Emitter-Coupled Differential Amplifier
　　7.7 The Source-Coupled Differential Pair
　　7.8 Examples of Multistage IC Amplifiers
　　Summary
　　Problems
　　8 Frequency Response
　　8.1 Bode Plots
　　8.2 The FET Common-Source Amplifier at High Frequencies
　　8.3 The Miller Effect
　　8.4 The Hybrid-π Model for the BJT
　　8.5 Common-Emitter Amplifiers at High Frequencies
　　8.6 Common-Base, Cascode, and Differential Amplifiers
　　8.7 Emitter Followers
　　8.8 Low-Frequency Response of RC-Coupled Amplifiers
　　Summary
　　Problems
　　9 Feedback and Oscillators
　　9.1 Effects of Feedback on Gain
　　9.2 Reduction of Nonlinear Distortion and Noise
　　9.3 Input and Output Impedances
　　9.4 Practical Feedback Networks
　　9.5 Design of Feedback Amplifiers
　　9.6 Transient and Frequency Response
　　9.7 Effects of Feedback on Pole Locations
　　9.8 Gain Margin and Phase Margin
　　9.9 Dominant-Pole Compensation
　　9.10 Examples of IC Amplifiers with Feedback
　　9.11 Oscillator Principles
　　9.12 The Wien-Bridge Oscillator
　　Summary
　　Problems
　　Anatomy of a Circuit Design:
　　A Cardiac Pacemaker
　　10 Output Stages and Power Supplies
　　10.1 Thermal Considerations
　　10.2 Power Devices
　　10.3 Clas-A Output Stages
　　10.4 Class-B Amplifiers
　　10.5 Linear Voltage Regulators
　　10.6 Linear-Power-Supply Design
　　Summary
　　Problems
　　11 Active Filters and Tuned Circuits
　　11.1 Active Low-Pass Filters
　　11.2 Active High-Pass Filters
　　11.3 Active Bandpass Filters
　　11.4 The Series Pesonant Circuit
　　11.5 The Parallel Resonant Circuit
　　11.6 Series-Parallel Transformations
　　11.7 Impedance-Matching Networks: A Design Example
　　11.8 Tuned Amplifiers
　　11.9 LC Oscillators
　　11.10 Crystal-Controlled Oscillators
　　Summary
　　Problems
　　12 Waveshaping Circuits and Data Converters
　　12.1 Comparators and Schmitt Trigger Circuits
　　12.2 Astable Multivibrators
　　12.3 The 555 Timer
　　12.4 Precision Rectifiers
　　12.5 Precision Peak Detector
　　12.6 Sample-and-Hold Circuits
　　12.7 Precision Clamp Circuits
　　12.8 Data Conversion
　　12.9 Digital-to-Analog Converters
　　12.10 Analog-to-Digital Converters
　　Summary
　　Problems
　　Anatomy of a Circuit Design:
　　A Precision AC-to-DC
　　Converter
　　A Discrete Resistors
　　B Data Sheet for the
　　2N2222A BJT
　　References

　　    《电子电路基础=Electronics：第2版》内容符合国内同类课程教学改革方向，具有以下特点：
　　    1. 以器件的应用为先导，而后讲解器件的工作原理，符合学生认知规律：
　　    2. 减少分立元件内容，加强集成电路器件与应用内容；
　　    3. 在几章内容之后，安排“综合设计实倒剖析”，教会学生综合运用前面几章所学知识进行电子电路设计；
　　    4. 习题安排不仅有利于学生巩固本章所学知识，同时为后面章节的学习做好铺垫。
　　    主要内容包：绪论，运算放大器，二极管及其电路，半导体三极管，场效应管，数字逻辑电路，差分和多极集成放大器，频率响应，反馈与振荡器，输出极与直流电源，有源滤波器与调谐电路，波形形成与数据转换电路。